Dana 60 Kingpin Cap Kit, no spring
SKU:
$79.95
$76.80
$76.80
per item
****AS OF 01-02-25, 3 kits in stock *******
This is a replacement cap for the passenger side of a Dana60 Steering axle.
It can also be used on the driver side if you have full hydraulic steering.
This replacement for the spring and stamped steel cover will tighten up your steering and not allow any play as the spring setup would.
"READ CAREFULLY, CUSTOM PART, NO RETURNS"
2 available
This is a replacement cap for the passenger side of a Dana60 Steering axle.
It can also be used on the driver side if you have full hydraulic steering.
This replacement for the spring and stamped steel cover will tighten up your steering and not allow any play as the spring setup would.
See note on returns below.
The setscrew in the center of the cap pushes against the center of the thick washer, which in turn holds pressure against the teflon (or brass) cone on top of the kingpin. The difference between this and the stock spring setup is that with a side load on the tire, the spring will allow the cone to move out of position, essentially letting the wheel float. This is especially significant if you are running large or heavy tires.
About the cover
This billet cover is made by Trusted Design Services, LLC of Bandera County, TX.
Made from solid 6061-T6 aluminum barstock.
Bolt pattern matches kingpin style Dana 60 steering axles.
Please check for clearance in your application before purchasing.
The following items are included in the kit:
1ea Cap
1ea Setscrew
1ea Locknut
1ea Compression Washer
4ea 1/2" Hex Bolts
Returned or cancelled items are subject to withholding shipping and processing fees.
Free shipping US48
It can also be used on the driver side if you have full hydraulic steering.
This replacement for the spring and stamped steel cover will tighten up your steering and not allow any play as the spring setup would.
See note on returns below.
The setscrew in the center of the cap pushes against the center of the thick washer, which in turn holds pressure against the teflon (or brass) cone on top of the kingpin. The difference between this and the stock spring setup is that with a side load on the tire, the spring will allow the cone to move out of position, essentially letting the wheel float. This is especially significant if you are running large or heavy tires.
About the cover
This billet cover is made by Trusted Design Services, LLC of Bandera County, TX.
Made from solid 6061-T6 aluminum barstock.
Bolt pattern matches kingpin style Dana 60 steering axles.
Please check for clearance in your application before purchasing.
The following items are included in the kit:
1ea Cap
1ea Setscrew
1ea Locknut
1ea Compression Washer
4ea 1/2" Hex Bolts
Returned or cancelled items are subject to withholding shipping and processing fees.
Free shipping US48
